HP 175X, 310X manual End of troubleshooting, 2000, 2001 Hewlett-Packard Company

53	The tagsize in a vendor specific field in the BOOTP reply is either 0, or
BAD BOOTP TAG	greater than the remaining number of unprocessed bytes in the vendor
SIZE	specified area.
54	The print server is currently in the process of obtaining its basic IP
BOOTP/RARP IN	configuration information through BOOTP/RARP.
PROGRESS
55	The print server is currently in the process of obtaining its basic IP
BOOTP/DHCP IN	configuration information through BOOTP/DHCP, and has not detected
PROGRESS	any errors.
56	The print server received a negative acknowledgment message from the
DHCP NAK	DHCP server in response to a configuration request.
57	The print server had received IP parameters from a DHCP server, but
UNABLE TO	communication with the DHCP server has been lost. Check status of the
CONNECT DHCP	DHCP server.
SVR	If an infinite lease was assigned, the print server will use the IP address
	of the most recent DHCP server used, but operation may be degraded
	until a DHCP server responds.
58	The printer does not support AppleTalk or AppleTalk extensions.
POSTSCRIPT
MODE NOT
SELECTED
59	Firmware download message. Currently downloading firmware to the
INCOMPLETE	print server, or the download did not complete properly.
F/W- MUST
DOWNLOAD
5A	Firmware download message. Download of firmware is complete.
TURN PRINTER	Power cycle the print server.
OFF/ON
83	The server has been shut down because of a configuration change or
DISCONNECTING	reset request. This message automatically clears after a few seconds,
FROM SERVER	unless the printer is off line, is in an error state, or is servicing another
	I/O port or another network protocol.
Back to Top

End of troubleshooting

If you have not been able to correct your print server problem using this troubleshooting procedure, you will need to contact HP technical support for further assistance. Click on the button below for details.

©2000, 2001 Hewlett-Packard Company