The print server automatically releases any names and IP addresses associated with the DHCP server and
After power to the print server is cycled, only BOOTP requests are sent and only BOOTP replies are processed. Any configuration of IP parameters done manually is ignored.
●DHCP
The print server automatically releases any names and IP addresses associated with the BOOTP server and
After power to the print server is cycled, only DHCP requests are sent and only DHCP replies are processed. Any configuration of IP parameters done manually is ignored.
●Manual
BOOTP and DHCP are disabled.
You should proceed to manually set all of the IP configuration parameters, including IP address, subnet mask, default gateway, and idle timeout. You can use the settings available in the same tool you are using.
Caution:
If the print server is switched from using an address allocated by a DHCP server to using a manually assigned address, that manually assigned address should be outside any DHCP range used for other devices on the network. An alternative is to tell the DHCP server that the print server's address is fixed so that it will never be allocated to another client.
Returning to factory defaults
You can return the print server to its
procedure.
©2000, 2001
