![](/images/new-backgrounds/1330581/330581229x1.webp)
General Jetdirect Information
Provides general print server status and identification information.
Message | Description |
Status | Current state of the print server. |
●I/O Card Ready the print server has successfully connected to the network and is awaiting data.
●I/O Card Initializing the print server is initializing the network protocols. For more information, see the status line for each protocol on the configuration page.
●I/O Card Not Ready there is a problem with the print server or its configuration.
| An error code and message are displayed if the print server is not ready. | |
Model Number | The model number of the HP print server (for example, J6035A or | |
| J6038A). |
|
Hardware | The | |
Address | server installed in or attached to the printing device. This address is | |
| assigned by the manufacturer. | |
Firmware | The firmware revision number of the print server currently installed in | |
Version | the printer. The format is | X.NN.NN, where X is a letter that depends |
| on the HP print server model. | |
Port Config | Identifies the link configuration of the | |
| server: |
|
| ● | 10 Mbps, |
●
●100TX HALF 100 Mbps,
●100TX FULL 100 Mbps,
●Unknown the print server is in an initialization state.
●Disconnected a network connection has not been detected. Check network cables.
Auto | Identifies whether IEEE 802.3u Autonegotiation on the 10/100TX port is |
Negotiation | enabled (on) or disabled (off). |
| On the print server will attempt to automatically configure itself onto the |
| network at the proper speed (10 or 100 Mbps) and mode (half or full |
| duplex). |
Manufacturing | The manufacturing identification code for use by HP support personnel. |
ID |
|
Date | Identifies the date of manufacture of the HP Jetdirect print server. |
Manufactured |
|