HP 310X, 175X manual Security, Admin Password setting, Access Control host access list

Email (SMTP) Server (for outgoing mail)

Scan Idle

Timeout

Specifies the outgoing email server (SMTP) for use of the scanning to email feature in the embedded web server. This mail server will be used when any user scans to email from the MFP (or

All-in-One device) attached to the print server. See also DNS Server above.

Specifies the number of seconds that an idle connection for scanning (either web scanning or the client's full-function scanning software) is allowed to remain open. If set to 0, the timeout is disabled and the connection will remain open until closed by the device at the other end.

Security

●Admin Password

●Access Control (host access list)

Admin Password setting

Click on the Networking tab at the top of the web page. In the left column of the page, beneath Security, select Admin Password. To assign a parameter setting, enter the desired value and click [Apply].

For controlled access to configuration and status information through the embedded web server and Telnet, use this page to set or clear an administrative password. If a password is set, you will be prompted for this password to access these print server web pages.

Access Control (host access list)

Click on the Networking tab at the top of the web page. In the left column of the page, beneath Security, select Access Control.

This page allows you to create a host access list on the print server. A host access list specifies individual host systems, or networks of host systems, that will be allowed to access the print server and the attached network printing device. Up to 10 entries can be included on the host access list. If the list is empty (no hosts are listed), any supported system can access the print server.

Note: Use caution with this feature. You may lose your ability to communicate with the print server if your system is improperly specified in the list.

Host systems are specified by their IP addresses or network number. If the network contains subnets, a “mask” may be used to identify whether the IP address designates an individual host system or a group of host systems.

To clear all entries in the host access list, enable the Clear Allow Table checkbox and click [Apply]. To add an entry into the host access list, use the IP address and Mask fields to specify a host, then click [Apply].