HP 310X, 175X manual Using Telnet to Erase the Existing IP Address, Telnet Commands and Parameters

Using Telnet to Erase the Existing IP Address

This procedure resets all TCP/IP parameters, but only affects the TCP/IP subsystem. After this has been done the print server should be power cycled. Parameters for other subsystems such as IPX/SPX (Novell NetWare) or AppleTalk are not affected.

(To reset all print server configuration parameters to factory default values, use the hardware cold reset procedure.)

1.Enter the Telnet command: cold-reset

2.Exit Telnet using one of the following commands, depending on your system.

save exit quit

3. When prompted whether to save settings that you have changed, enter y.

Telnet Commands and Parameters

List of the available Telnet commands and parameters.

Note:

If a parameter is supplied dynamically (for example, from a BOOTP, TFTP, or DHCP server), its value cannot be changed using Telnet without first setting manual configuration, using the ip-configcommand).

Whenever you are manually changing an IP address, you should also reconfigure the subnet mask and default gateway at the same time.

User control commands in Telnet

Telnet Parameter	Description and Values
?	Displays the Telnet commands and help commands.
/	Displays current values.
menu	Displays the menu interface for further configuration entries.