HP 310X, 175X manual There is a network congestion problem

03

LAN ERROR- EXTERNAL LOOPBACK

07

LAN ERROR- CONTROLLER CHIP

08

LAN ERROR- INFINITE DEFERRAL

09

LAN ERROR- BABBLE

0A

LAN ERROR- NOSQE

0C

LAN ERROR- RECEIVER OFF

The print server is incorrectly connected to your network or is defective. Make sure your print server is correctly attached to your network. In addition, check the cabling and connectors.

Check the network connections. If the connections are intact, run the power-on self-test: turn the printer off, then on again. If the error persists, replace the print server.

There is a network congestion problem.

Note: If the print server is not connected to the network, this error cannot occur.

Check the network connections. If the connections are intact, run the power-on self-test: turn the printer off, then on again. If the error persists, replace the print server.

Check the network connections. If the connections are intact, run the power-on self-test: turn the printer off, then on again. If the error persists, replace the print server.

There may be a problem with your network cabling or the print server. Check the cabling and connectors on your Ethernet network. If you cannot find a problem with your network cabling, run the power-on self-test: remove and re-attach the power module connector on the print server. If the error persists, there is a problem with the print server.

0D	There may be a problem with your network cabling or the print server.
LAN ERROR-	Check the cabling and connectors on your Ethernet network. If you
TRANSMITTER	cannot find a problem with your network cabling, run the power-on
OFF	self-test: remove and re-attach the power module connector on the print
	server. If the error persists, there is a problem with the print server.
0E	Check the network connections. If the connections are intact, run the
LAN ERROR-	power-on self-test: remove and re-attach the power module connector
LOSS OF	on the print server. If the error persists, replace the print server.
CARRIER
10	There may be a problem with your network cabling or the print server.
LAN ERROR-	Check the cabling and connectors on your network. If you cannot find a
UNDERFLOW	problem with your network cabling, run the power-on self-test: remove
	and re-attach the power module connector on the print server. If the
	error persists, there is a problem with the print server.
11	There is a problem with your network cabling or external network
LAN ERROR-	configuration. Verify operation of the hub or switch port.
RETRY FAULTS
12	With a 10Base-T or 100Base-TX port connected, Link Beat is not
LAN ERROR- NO	sensed. Check the network cable, and verify that the concentrator or hub
LINKBEAT	is providing Link Beat.