Troubleshooting
Use this chart to help you solve daily operational problems. If there are any problems you cannot solve, contact your JVC’s service center.
General
PROBLEM | POSSIBLE CAUSE | SOLUTION |
The power does not come on. | The power cord is not plugged in. | Plug the power cord into an AC outlet. |
|
|
|
No sound from speakers. | Speaker signal cables are not connected. | Check speaker wiring and reconnect if necessary. |
| An incorrect source is selected. | Select the correct source. |
| Muting is activated. | Press MUTING to cancel the mute. |
| An incorrect input mode (analogue or | Select the correct input mode (analogue or digital). |
| digital) is selected. |
|
| Connections are incorrect. | Check connections. |
| TV Direct is activated. | Deactivate TV Direct (see pages 13 and 20). |
|
|
|
Buttons cannot be used. | TV Direct is activated. | Deactivate TV Direct (see pages 13 and 20). |
|
|
|
Sound from one speaker only. | The balance is set to one extreme. | Adjust the balance properly (see page 22). |
|
|
|
The unit turns off and becomes standby | Speakers are overloaded because of high | 1. Stop the playback source. |
mode. | volume. | 2. Turn on the unit again, and adjust the volume. |
| Speakers are overloaded because of a | Check the speaker wiring. |
| short circuit at the speaker terminals. | If speaker wiring is not |
|
| dealer. |
|
|
|
| The unit is overloaded because of a high | Consult your dealer after unplugging the power cord. |
| voltage. |
|
Remote control does not operate as | The remote control is not ready for your | Press a source selecting button or TONE first, then |
you intend. | intended operation. | press the buttons you want to use. (See pages 21, |
|
| 35, 36 and 37.) |
|
|
|
Remote control does not work. | There is an obstruction hiding the remote | Remove the obstruction. |
| sensor on the unit. |
|
| Batteries are weak. | Replace batteries. |
| The mode selector is set to the incorrect | Set the mode selector to the proper position. |
| position. |
|
|
|
|
Remote control does not work for the | You cannot use this remote control to | Use the remote control supplied with the VDR. |
VDR. | operate the VDR. |
|
|
|
|
Bass sound is reinforced too much | Appropriate bass level is not selected. | Adjust audio position level (see page 22). |
when listening in stereo. |
|
|
38