Nortel Networks 2300 Series manual Show ip telnet, WSS show ip telnet

		IP Services Commands 165
	Table 9: Output for show ip route (continued)
	Field	Description
	Gateway	Next-hop router for reaching the route destination.
		Note: This field applies only to static routes.
	VLAN:Interface	Destination VLAN, protocol type, and IP address of the route.
		Because direct routes are for local interfaces, a destination IP
		address is not listed.
		The destination for the IP multicast route is MULTICAST.
		For static routes, the value Down means the WSS does not have
		an interface to the destination’s next-hop router. To provide an
		interface, configure an IP interface that is in the same IP subnet
		as the next-hop router. The IP interface must be on a VLAN
		containing the port that is attached to the default router.
	See Also
• clear ip route on page 101
• set interface on page 109
• set ip route on page 116
• show interface on page 149
• show vlan config on page 89

show ip telnet

Displays information about the Telnet management port.

Syntax	show ip telnet
Defaults	None.
Access	All.

Examples The following command shows the status and port number for the Telnet management interface to the WSS:

WSS> show ip telnet

Server Status Port

----------------------------------

Enabled 23

Table 26 describes the fields in this display.

Nortel WLAN—Security Switch 2300 Series Command Line Reference