Nortel Networks 2300 Series manual Set mobility-domain mode member seed-ip

230Mobility Domain Commands

success: change accepted.

WSS# set mobility-domain member 192.168.1.10

success: change accepted.

See Also

•clear mobility-domain member on page 218

•show mobility-domain config on page 222

set mobility-domain mode member seed-ip

On a nonseed WSS, sets the IP address of the seed WSS. This command is used on a member WSS to configure it as a member. If the WSS is currently part of another Mobility Domain or using another seed, this command overwrites that configuration.

Syntax set mobility-domain mode member seed-ip ip-addrkey hex-bytes

ip-addr		IP address of the Mobility Domain member, in dotted decimal notation.
key hex-bytes		Fingerprint of the public key to use for WSS-WSSsecurity. Specify the
		key as 16 hexadecimal bytes. Use a colon between each byte, as in the
		following example:
		00:11:22:33:44:55:66:77:88:99:aa:bb:cc:dd:ee:ff
Defaults	None.
Access	Enabled.
History
Version 5.0		Option key hex-bytesadded.

Examples The following command sets the current WSS as a nonseed member of the Mobility Domain whose seed has the IP address 192.168.1.8:

WSS# set mobility-domain mode member seed-ip 192.168.1.8 mode is: member

seed IP is: 192.168.1.8

See Also

•clear mobility-domain on page 218

•show mobility-domain config on page 222

set mobility-domain mode member secondary-seed- ip

This command is used on a member WSS to configure it as a member of secondary seed.

NN47250-100 (Version 02.51)