SYSTEM SETTINGS GUIDE
DEVICE CONTROL
These programs are used to configure settings for hardware functions of the machine. To access one of these programs, select "DEVICE CONTROL" in the mode selection screen, select the desired program in the device control screen, and press the [OK] key.
WAITING COPY LAMP SETTING
This program is used to select whether the copy lamp (light source) is on or off when the machine is in standby mode. If the copy lamp (light source) is set to turn off in standby mode, power will be conserved, however, the first copy time will be longer than if the lamp is on.
The factory default setting is "ON".
Select "WAITING COPY LAMP SETTING" and press the [OK] key. The following screen will appear.
COPY LAMP SETTING
ON
OFF
1 Select "ON" or "OFF" with the [ ] or [ ] key.
2 Press the [OK] key.
OFFSET FUNCTION
When the offset function is enabled, sets of output will be offset from each other for easy separation when copying is performed in sort mode or
The function is initially enabled (factory default setting) for both the top tray and the centre tray.
Select "OFFSET FUNCTION" and press the [OK] key. The following screen will appear.
MEM. FOR PRINTER
(When the dual function board is installed)
The machine is equipped with memory that stores scanned original image data. Part of this memory is also used to store print data. This program is used to set the percentage of memory that is allocated to the print function. The memory allocation can be set from 30% to 70% in increments of 10%.
The factory default setting is "50%".
Select "MEM. FOR PRINTER" and press the [OK] key. The following screen will appear.
MEM. FOR PRINTER 30%
40%
50% 60%1 Select the desired percentage with the [ ] or [ ] key.
2 Press the [OK] key.
The memory for storing original image data Note and print data is 16 MB. An optional memory module can be installed to expand memory
to 272 MB (the module adds 256 MB).
USB2.0 MODE
This sets the data transfer speed of the USB 2.0 port. The factory default setting is
If you wish to use USB 2.0
Select "USB2.0 MODE" and press the [OK] key. The following screen will appear.
OFFSET FUNCTION
UPPER TRAY
CENTRE TRAY
1 Select "UPPER TRAY" or "CENTRE TRAY" with the [] or [] key.
2 Press the [OK] key.
USB2.0 MODE
HI-SPEED
1 Select the transfer speed with the [] or [ ] key.
2 Press the [OK] key.
•The setting is enabled and a checkmark appears in the checkbox.
•If this procedure is performed when the setting is already enabled, the checkmark is cleared and the setting is disabled.
*This function is not available in some countries and regions.
82