BEFORE USING THE PRODUCT
Special paper
Follow these guidelines when using special paper.
•Use SHARP recommended transparency film and label sheets. Using other than SHARP recommended paper may result in misfeeds or smudges on the output.
•There are many varieties of special paper available on the market, and some cannot be used with this machine. Before using special paper, contact your authorised service representative.
•Before using other than SHARP recommended paper, make a test copy to see if the paper is suitable.
LOADING PAPER |
| |
1 | ||
Make sure that the machine is not copying or printing, and then follow these steps to load paper. | ||
| ||
|
|
Loading paper in a tray
1 Gently lift and pull out the paper tray.
If you are adding the same size of paper, go to step 3. If you are loading a different size of paper, go to the next step.
4 Fan the paper.
Fan the paper well before loading it. If the paper is not fanned,
2 Adjust the plates in the tray to the length and width of the paper.
Plate B |
| • The plate A is a |
|
| guide. Grasp the locking knob |
|
| on the guide and slide the |
|
| guide to the indicator line of |
| Plate A | the paper to be loaded. |
|
|
•The plate B is an
•When using 11" x 17" sized paper store the plate B in the
slot at the left front of the paper tray.
3 Push the pressure plate down.
Push the centre of the pressure plate down until it locks into place.
5 Place the paper in the tray.
• | Do not load paper higher than the line on |
Note | the tray (up to 250 sheets). |
•Make sure that the paper fits under the tab on the right side of the tray.
•Make sure the stack of paper is straight before loading it. When adding paper, take the remaining paper out and combine it into a single stack with the new paper.
6 Gently push the paper tray back in.
Push the upper paper tray in completely.
If the size of the loaded paper is different Note from the size shown in the display, be sure
to follow the procedure in "CHANGING THE PAPER SIZE SETTING OF A TRAY" (page
21)to change the paper size setting of the tray.
19