COPY FUNCTIONS
USING THE BYPASS TRAY TO COPY A SPECIAL SIZE ORIGINAL
When the bypass tray is being used for copying and an original that is placed on the document glass is detected as being a special size, the display will prompt the user to set the original size. To make a copy in this type of situation, follow the steps below.
1 Load paper in the bypass tray and place the original on the document glass.
2 Touch the [PAPER SELECT] key and then select the bypass tray.
RE PAPER SELECT COPY RATIO AUTO IMAGE | [OK]:ORIG. SIZE | |
ODE RESOLUTION ADDRESS | FORMAT O | |
AM RESOLUTION ADDRESS | BROADCAST O | ENTER |
| ||
|
|
|
AUTO
100%
EXTRA
A message will appear asking you whether you wish to set the original size or make the copy without setting it. To make a copy without setting the original size, press the [START] key ( ). To set the original size, go to step 3.
If you load thick paper in the bypass tray, Note press the [PAPER] key until "EXTRA" is
highlighted. The paper type is set to thick paper. The setting is cleared when "Auto clear" works or the [CA] key is pressed.
For restrictions on paper types and weights, see "PAPER" (page 18).
[OK]:ORIG. SIZE ENTER
|
| AUTO |
|
| 100% |
|
| EXTRA |
3 Press the [OK] key. | ||
BACK OK | GHI | ORIG. SIZE ENTER |
|
AB
PQRS
| A4R | |
PY | A5 | |
SIZE INPUT | ||
AN | ||
|
The original size selection screen appears with "SIZE INPUT" selected.
4 Select AB or inches with the [] or [] key, and then select the original size with the [ ] or [] key.
PQ
ED COPY
LEX SCAN
LEX SCAN
ACC
5 Press the [OK] key.
If "SIZE INPUT" was selected in step 4:
OK | SIZE | INPUT |
| ||
| SIZE(mm) | |
| X: | 210 |
| Y: | 148 |
The size entry screen appears and is ready for entry of the width of the original.
If you selected inches in step 4, the screen will
Note | be ready for you to enter the width in inches. |
|
If other than "SIZE INPUT" was selected in step 4:
You will return to the base screen. Go to step 8.
6 | Select "X" (width) with the [ | ] or [ | ] key |
| 4 |
| and enter the width with the [ | ] or [ | ] key, | ||
| and then do the same for the length (Y). |
SIZE INPUT
SIZE(mm)
X: 100
Y: 100
• Any number from 64 mm to 432 mm
Note to 17") can be entered for the width, and any number from 64 mm to 297 mm
•The entered size is retained until the power is turned off, even if "SIZE INPUT" is selected again and the entry screen of step 5 is displayed.
7 Press the [OK] key.
OK | You will return to the base |
| screen. |
8 Press the [START] key ( ).
MNO | Copying begins. |
| |
WXYZ |
|
| |
|
51