TROUBLESHOOTING AND MAINTENANCE
MISFEED IN THE MACHINE
To remove a paper misfeed from the machine, the bypass tray and then the side cover must be opened. Check whether the misfeed occurred in A, B, or C below and then follow the misfeed removal procedure for that location.
1 Open the bypass tray and then the | 2 Determine where the misfeed |
side cover. | occurred. |
| Location B | 2 |
| If paper is misfed here, go to | |
Location C | "Misfeed in B" (page 32). |
If paper is misfed here, go to "Misfeed in C" (page 33).
Location A
If paper is misfed here, go to "Misfeed in A" (below).
Misfeed in A
1 Open the front cover.
Push gently on both ends of the front cover to open it.
2 Turn the roller rotating knob in the direction of the arrow to remove the misfed paper.
Roller rotating | Be careful not to tear the misfed | |
paper during removal. | ||
knob |
Warning | The fusing unit is hot. Do not touch |
the fusing unit when removing | |
| misfed paper. Doing so may cause a |
| burn or injury. |
Caution | Do not touch the photoconductive drum |
(green portion) when removing the misfed | |
| paper. Doing so may damage the drum and |
| cause smudges on copies. |
3 Close the front cover and the side cover.
The message " Clear paper path." will be cleared and copying will be possible.
• | When closing the front cover, gently hold |
Note | both ends. |
•When closing the side cover, hold the handle.
•If the message does not clear, check again to make sure that no pieces of paper remain.
31