Sharp MX-M200D Default Exposure, Rotation Copy, Stream Feeding, Sort Auto Select, Auto Auto

SYSTEM SETTINGS GUIDE

Select "DEFAULT TRAY SET" and press the [OK] key. The following screen will appear.

DEFAULT TRAY SET

TRAY 1

TRAY 2

TRAY 3

TRAY 4

1 Select the tray with the [ ] or [ ] key.

2 Press the [OK] key.

DEFAULT EXPOSURE

ROTATION COPY

(When the dual function board is installed)

If the orientation of the original does not match that of the paper, the image can be rotated.

Rotation copy operates when automatic paper selection or automatic ratio selection operates. The function is initially enabled (factory default setting).

If the image is both rotated and reduced, the Note position of the copied image will vary

depending on the orientations of the original and the paper.

Original Paper Copy

This program is used to select the exposure mode/level that is initially selected when the [EXPOSURE] key is pressed.

The factory default setting is "AUTO".

Select "DEFAULT EXPOSURE" and press the [OK] key. The following screen will appear.

DEFAULT EXPOSURE

AUTO AUTO

TEXT

PHOTO

1 Select the exposure mode with the [ ] or [ ] key.

2	If you selected "TEXT" or "PHOTO", set
	the exposure level with the [ ] or [ ] key.
3	Press the [OK] key.

STREAM FEEDING

When stream feeding mode is enabled, additional originals which are placed in the SPF within 5 seconds after the previous original was fed will be copied automatically. (If more than 5 seconds elapse, the [START] key ( ) must be pressed again.)

This function can be used when scanning originals in copy and scan modes.

The function is initially disabled (factory default setting).

To enable stream feeding, select "STREAM FEEDING" and press the [OK] key so that a checkmark appears in the checkbox.

To disable stream feeding, select "STREAM FEEDING" once again and press the [OK] key so that the checkmark is cleared from the checkbox.

To enable rotation copy, select "ROTATION COPY" and press the [OK] key so that a checkmark appears in the checkbox.

To disable rotation copy, select "ROTATION COPY" once again and press the [OK] key so that the checkmark is cleared from the checkbox.

SORT AUTO SELECT

(When the dual function board is installed)

This program is used to select the default output mode when the SPF is used for copying.

The initial factory setting is "SORT".

Select "SORT AUTO SELECT" and press the [OK]	7
key. The following screen will appear.

SORT AUTO SELECT

NO SORT

SORT

1	Select the output mode with the [ ] or [ ]
	key.
2	Press the [OK] key.

87