Sharp MX-M200D Copy Functions, Normal Copying, Copying from the document glass, Ready to copy

4

COPY FUNCTIONS

This chapter explains the basic procedures for making copies, including selection of the copy ratio and other copy settings.

NORMAL COPYING

This section explains how to make a regular copy.

If "Auditing mode" has been enabled (page 23), enter your 5-digit account number.

Copying from the document glass

1 Open the SPF and place the original face down on the document glass.

Align the upper left-hand corner of the original with the tip of the mark.

The original size is automatically detected.

An original up to A3 (11" x 17") can be

Note placed on the document glass.

2 Close the SPF.

After placing the original, be sure to close the SPF. If left open, parts outside of the original will be copied black, causing excessive use of toner.

If the original is a non-standard size or the Note size was not detected correctly, see

"SELECTING THE ORIGINAL SIZE" (page 50).

3 Make sure that the desired paper tray is selected.

Ready to copy.

A4

	AUTO
100%
A4	AUTO

To load paper, see "LOADING PAPER" (page 18).

• If the auto paper select function has been

Note disabled in the system settings (page 88), use the [PAPER SELECT] key to select the desired paper size.

•If you wish to use a size of paper different from the size automatically selected by the machine, use the [PAPER SELECT] key to select the desired paper size.

•Paper in a different orientation from the original can be selected if the auto paper select or auto image function has been selected. In this case, the image of the original will be rotated.

•To make a copy of a small original such as a card, follow the procedure in "USING THE BYPASS TRAY TO COPY A SPECIAL SIZE ORIGINAL" (page 51).

•To use the bypass tray, select it manually.

4 Set the number of copies.

If you are making two or more copies each Note of multiple original pages, you can select the

sort function to collate the copies into sets. (Page 64)

45