Sharp MX-M200D, MX-M160D operation manual Replacing the Toner Cartridge, Close the front cover

REPLACING THE TONER CARTRIDGE

When the toner replacement icon ( ) appears, little toner remains. Obtain a replacement cartridge as soon as possible. When the message " Add toner. Can not copy or print." appears in the display, the toner cartridge must be replaced before copying can be resumed. Follow the steps below to replace the toner cartridge.

• During a long copy run or when copying originals with many dark areas, the message "Toner replenishment in Note progress." may appear and copying will stop even though toner remains. The machine will feed toner for about

2 minutes. When the START indicator lights up, press the [START] key ( ) to resume copying.

•When the toner cartridge replacement required icon ( ) appears in the display, little toner remains and thus copies may be faint.

1 Open the front cover.

Push gently on both ends of the front cover to open it.

2 Pull the toner cartridge out while pressing on the toner cartridge lock release lever.

Toner cartridge	When pulling out the toner
lock release lever	cartridge, place your other hand
	on the indentation of the
	cartridge.

• After removing the toner cartridge, do not Caution shake it or tap it. Doing so may cause

toner to leak from the cartridge.

•	Put the old cartridge immediately in the
	bag contained in the box of the new
	cartridge.
•	Do not throw the toner cartridge
Warning	into a fire. Toner may fly and cause
	burns.
•	Store toner cartridges out of the
	reach of small children.

3 Remove the new toner cartridge from the bag. Grasp the cartridge on both sides and shake it horizontally four or five times.

4 or 5 times

• Do not hold the cartridge by the shutter. It Caution may fall. Grasp the hand grip when

holding the cartridge.

•Be sure to shake the cartridge only before the tape is removed.

4 While pressing down on the toner cartridge lock release lever, insert the toner cartridge along the guides all the way in.

If there is any dirt or dust on the

toner cartridge, remove it before 2 installing the cartridge.

5 Close the front cover.

	The toner cartridge replacement
	required icon ( ) will no longer
	appear and copying will be
	possible.
•	Even after a new toner cartridge is
Note	installed, the toner cartridge replacement
	required indicator ( ) may still appear,
	indicating that copying cannot be resumed
	(toner is not fed sufficiently). In this case,
	open and close the front cover. The
	machine will feed toner again for about two
	minutes and then copying can be resumed.

•Before closing the front cover, make sure that the toner cartridge is correctly installed.

•When closing the front cover, gently hold both ends.

35