Sharp MX-M160D, MX-M200D operation manual Selecting the Original Size, ORIG. Size Enter Inch

COPY FUNCTIONS

SELECTING THE ORIGINAL SIZE

If you loaded a non-standard size* original or the original size was not correctly detected, set the original size manually. Perform the following steps after placing the document in the document feeder tray or on the document glass.

* Standard sizes:

Note	The following sizes can be detected correctly: A3, B4, A4, A4R, A5 (11" x 17", 8-1/2" x 14", 8-1/2" x 13", 8-1/2" x
	11", 8-1/2" x 11"R, 5-1/2" x 8-1/2"). If a non-standard size original is placed (including special sizes), the closest
	standard size may be displayed, or the original size may not appear.

1 Press the [SPECIAL FUNCTION] key.

ON LINE		SPECIAL	FUNCTION
DATA	SPECIAL
	FUNCTION	SPECIAL	MODES
		ORIG. SIZE		ENTER
LINE	COPY EXPOSURE PAPER SE	PAPER SIZE		SET
DATA	SCAN COLOUR MODE RESOLUT	DISPLAY	CONTRAST
The special function

screen will appear.

2 Select "ORIG. SIZE ENTER" from the menu with the [] or [] key.

PQ	SPECIAL	FUNCTION
	SPECIAL	MODES
ED COPY	ORIG. SIZE		ENTER
LEX SCAN	PAPER SIZE		SET
LEX SCAN
ACC	DISPLAY	CONTRAST
3 Press the [OK] key.
GHI	ORIG. SIZE		ENTER
BACK OK

5 Press the [OK] key.

OK	You will return to the base
	screen and the selected original
	size will appear in the original
	size display.

Selecting an inch original size

6 Select the original size with the [] or [ ] key.

ORIG. SIZE ENTER

INCH

11x17 812 x14 812 x11

To return to selection of AB original sizes, press the [ ] key to return to step 4.

PQRS

PY

A3 B4

AB

7 Press the [OK] key.

AN	A4
The original size selection
screen will appear.

4 Select the original size with the [] or [ ] key.

OK	You will return to the base
	screen and the selected original
	size will appear in the original
	size display.

To cancel an original size selection, press

Note the [CA] key.

The selected original size is highlighted.

ORIG. SIZE ENTER

AB

A3

B4

A4

•To select an inch original size, press the [] key and go to step 6.

•If you selected "SIZE INPUT", follow steps 4 through 6 of the procedure in "USING THE BYPASS TRAY TO COPY A SPECIAL SIZE ORIGINAL" (page 51) to set the horizontal and vertical dimensions of the original.

50