Sharp MX-M160D, MX-M200D operation manual Disabling Enabling Auto Tray Switching, Paper Size SET

BEFORE USING THE PRODUCT

DISABLING (ENABLING) AUTO TRAY SWITCHING

When auto tray switching is enabled and paper runs out during copying or printing, the job will continue using paper from a different tray if that tray has the same size of paper in the same orientation. (This function does not operate when using the bypass tray or when a fax is being printed.) This function has been enabled at the factory. If you prefer to disable the function, follow the steps below.

1 Press the [SPECIAL FUNCTION] key.

ON LINE		SPECIAL	FUNCTION
DATA	SPECIAL
	FUNCTION	SPECIAL	MODES
		ORIG. SIZE		ENTER
LINE	COPY EXPOSURE PAPER SE	PAPER SIZE		SET
DATA	SCAN COLOUR MODE RESOLUT	DISPLAY	CONTRAST
The special function

screen will appear.

The above screen appears in copy mode.

5 Press the [OK] key.

OK	PAPER	SIZE SET
	AUTO	TRAY
	SWITCHING

When a checkmark does not appear in the checkbox, the auto tray switching function will not operate.

2 Select "PAPER SIZE SET" with the [] or [] key.

6 Press the [] key.

PQ	SPECIAL	FUNCTION
	SPECIAL	MODES
ED COPY	ORIG. SIZE		ENTER
LEX SCAN	PAPER SIZE		SET
LEX SCAN
ACC	DISPLAY	CONTRAST
3 Press the [OK] key.

You will return to the paper size setting screen.

PAPER SIZE		SET
	A4	A3
	A3	B4
		A4
		A4R

GHI	PAPER SIZE	SET
BACK OK
PQRS	A4	A3
	A3	B4
PY		A4
		A4R
AN
The paper size setting
screen will appear.

4 Press the [] key repeatedly until "AUTO TRAY SWITCHING" appears.

PAPER SIZE SET

AUTO TRAY

SWITCHING

To re-enable auto tray switching, press the [OK] key in the screen of step 5 so that a checkmark appears.

Move the cursor to the lowest tray and then press the [] key again. The above screen will appear.

22