Sharp MX-M160D Copying from the SPF, Press the Start key to begin copying, Stream feeding mode

MNO

WXYZ

@.-_

AD-END

COPY FUNCTIONS

5 Press the [START] key () to begin copying.

MNO	The copy will be delivered to the
WXYZ	centre tray.
@.-_
AD-END

Copying from the SPF

1 Open the SPF and make sure that an original has not been left on the document glass. Gently close the SPF.

2 Adjust the original guides to the size of the original(s).

3 Place the original(s) face up in the document feeder tray.

The original size appears in the display and the most suitable paper size is automatically selected.

Insert the stack into the document feeder tray until it stops.

• If the original is a non-standard size or the

Note size was not detected correctly, see

"SELECTING THE ORIGINAL SIZE" (page 50).

•If the auto paper select function has been disabled in the system settings (page 88), use the [PAPER SELECT] key to select the desired paper size.

•To copy onto paper of a different size, press the [PAPER SELECT] key and select the desired paper size.

•Paper in a different orientation from the original may be selected if the auto paper select or auto image function has been selected. In this case, the image of the original will be rotated.

•To use the bypass tray, select it manually.

•Do not place originals of different sizes together in the document feeder tray. This may cause misfeeds.

• The centre tray can hold a maximum of

Note 250 sheets (150 sheets when the job separator tray kit is installed).

•About one minute after copying ends, "Auto clear" (page 18) activates and restores the copy settings to the default settings. The setting for "Auto clear" can be changed in the system settings. (Page 83)

•To cancel a copy job in progress, press the [C] key.

•Differences in copy conditions may cause the position of the printed copy image to vary even the copies are of the same original on the same paper. For more information, see "Points concerning the position of the printed copy image" on page 47.

4 Set the number of copies.

5 Press the [START] key () to begin copying.

The copies are delivered to the centre tray.

The default output mode for copying from the SPF is sort

mode. (Page 64)

The output mode can be changed using the automatic sort selection setting in the system settings. (Page 87)

•	The centre tray can hold a maximum of
Note	250 sheets (150 sheets when the job
	separator tray kit is installed).

•About one minute after copying ends, "Auto clear" (page 18) activates and restores the copy settings to the initial settings. The duration of time after which "Auto clear" clears the copy settings can be changed in the system settings. (Page 83)

•To stop copying in the middle of a run, press the [C] key. If you find it difficult to remove the original from the document feeder tray, open the feeding roller cover before removing the original. If you pull out the original without opening the feeding roller cover, the original may become dirty.

Stream feeding mode

If stream feeding mode has been enabled in the system settings (page 87), the message "Set originals for stream feeding." will appear in the display for 5 seconds after all originals have been fed from the SPF. Any new originals placed in the SPF while this message appears will be fed and copied automatically.

46