Nortel Networks 2300 Series manual Set igmp proxy-report, WSS# set igmp oqi 200 vlan orange

	IGMP Snooping Commands 429
Syntax set igmp oqi seconds [vlan vlan-id]
oqi seconds	Number of seconds that the WSS waits for a general query to arrive
	before electing itself the querier. You can specify a value from 1 through
	65,535.
vlan vlan-id	VLAN name or number. If you do not specify a VLAN, the timer change
	applies to all VLANs.

Defaults The default other-querier-present interval is 255 seconds (4.25 minutes). Access Enabled.

Usage A WSS cannot become the querier unless the pseudo-querier feature is enabled on the switch. When the feature is enabled, the switch becomes the querier for a subnet so long as the switch does not receive a query message from a router with a lower IP address than the IP address of the switch in that subnet. To enable the pseudo-querier feature, use set igmp querier.

Examples The following command changes the other-querier-present interval on VLAN orange to 200 seconds:

WSS# set igmp oqi 200 vlan orange

success: change accepted.

See Also

•set igmp lmqi on page 416

•set igmp qi on page 420

•set igmp qri on page 420

•set igmp querier on page 421

•set igmp mrouter on page 417

•set igmp rv on page 422

set igmp proxy-report

Disables or reenables proxy reporting by a WSS on one VLAN or all VLANs.

Syntax set igmp proxy-report {enable disable} [vlan vlan-id]

enable	Enables proxy reporting.
disable	Disables proxy reporting.
vlan vlan-id	VLAN name or number. If you do not specify a VLAN, proxy reporting is
	disabled or reenabled on all VLANs.

Defaults Proxy reporting is enabled on all VLANs by default.

Access Enabled.

Nortel WLAN—Security Switch 2300 Series Command Line Reference