Nortel Networks 2300 Series Set igmp querier, Syntax set igmp qri tenth-seconds vlan vlan-id

IGMP Snooping Commands 431

Syntax set igmp qri tenth-seconds [vlan vlan-id]

qri tenth-seconds	Amount of time (in tenths of a second) that the WSS waits for a
	receiver to respond to a group-specific query message before
	removing the receiver from the receiver list for the group. You can
	specify a value from 1 through 65,535.
vlan vlan-id	VLAN name or number. If you do not specify a VLAN, the timer
	change applies to all VLANs.

Defaults The default query response interval is 100 tenths of a second (10 seconds). Access Enabled.

Usage The query response interval is applicable only when the WSS is querier for the subnet. For the switch to become the querier, the pseudo-querier feature must be enabled on the switch and the switch must have the lowest IP address among all the devices eligible to become a querier. To enable the pseudo-querier feature, use set igmp querier.

Examples The following command changes the query response interval on VLAN orange to 50 tenths of a second (5 seconds):

WSS# set igmp qri 50 vlan orange

success: change accepted.

See Also

•set igmp lmqi on page 416

•set igmp oqi on page 418

•set igmp qi on page 420

•set igmp querier on page 421

•set igmp rv on page 422

set igmp querier

Enables or disables the IGMP pseudo-querier on a WSS, on one VLAN or all VLANs.

Syntax set igmp querier {enable disable} [vlan vlan-id]

enable	Enables the pseudo-querier.
disable	Disables the pseudo-querier.
vlan vlan-id	VLAN name or number. If you do not specify a VLAN, the pseudo-
	querier is enabled or disabled on all VLANs.

Defaults The pseudo-querier is disabled on all VLANs by default. Access Enabled.

Usage Nortel recommends that you use the pseudo-querier only when the VLAN contains local multicast traffic sources and no multicast router is servicing the subnet.

Nortel WLAN—Security Switch 2300 Series Command Line Reference