Nortel Networks 2300 Series manual Set port type wired-auth, WSS# set ap 1 radio 1 antennatype

54Port Commands

To manage an AP on a switch model that does not have 10/100 Ethernet ports, use the set ap command to configure a AP connection on the switch.

Examples The following commands set port 2 for AP model 2330, enable PoE on the port, and specify external antenna model 24453 for the 802.11b/g radio:

WSS# set port type ap 2 model 2330 poe enable

This may affect the power applied on the configured ports. Would you like to continue? (y/n) [n]y

success: change accepted.

WSS# set ap 1 radio 1 antennatype 24453

success: change accepted.

The following command sets ports 4 through 6 for AP model 2330 and enables PoE on the ports:

WSS# set port type ap 4-6 model 2330 poe enable

This may affect the power applied on the configured ports. Would you like to continue? (y/n) [n]y

success: change accepted.

The following command resets port 5 by clearing it:

WSS# clear port type 5

This may disrupt currently authenticated users. Are you sure? (y/n) [n]y success: change accepted.

See Also

•clear ap on page 24

•clear port type on page 27

•set ap radio antennatype on page 263

•set ap on page 33

•set port type wired-auth on page 44

•set system countrycode on page 63

set port type wired-auth

Configures a WSS port for a wired authentication user.

Note. Before changing the port type from ap to wired-author from wired-authto ap, you must reset the port with the clear port type command.

NN47250-100 (Version 02.51)