Nortel Networks 2300 Series Set port media-type, WSS# set port-group name server1 1-5 mode on

46Port Commands

Syntax set port-group name group-nameport-listmode {on off}

name group-name	Alphanumeric string of up to 255 characters, with no spaces.
port-list	List of physical ports. All the ports you specify are configured together as
	a single logical link.
mode {on off}	State of the group. Use on to enable the group or off to disable the group.
	The group is enabled by default.

Defaults Once configured, a group is enabled by default. Access Enabled.

Usage Do not use dashes or hyphens in a port group name. If you do, WSS Software will not display or save the port group.

You can configure up to 16 ports in a port group, in any combination of ports. The port numbers do not need to be contiguous and you can use 10/100 Ethernet ports and gigabit Ethernet ports in the same port group.

After you add a port to a port group, you cannot configure port parameters on the individual port. Instead, change port parameters on the entire group. Specify the group name instead of an individual port name or number in port configuration commands.

To add or remove ports in a group that is already configured, change the mode to off, add or remove the ports, then change the mode to on.

Examples The following command configures a port group named server1 containing ports 1 through 5, and enables the link:

WSS# set port-group name server1 1-5 mode on

success: change accepted.

The following commands disable the link for port group server1, change the list of ports in the group, and reenable the link:

WSS# set port-group name server1 1-5 mode off success: change accepted.

WSS# set port-group name server1 1-4,7 mode on success: change accepted.

See Also

•clear port-group on page 25

•show port-group on page 47

set port media-type

Disables the fiber interface and enables the copper interface on a 2380 gigabit Ethernet port.

NN47250-100 (Version 02.51)