Nortel Networks 2300 Series manual Output for show ntp, Synced

		IP Services Commands 167
	Table 11: Output for show ntp
Field	Description
NTP client	State of the NTP client. The state can be one of the following:
	•	Enabled
	•	Disabled
Current update-interval	Number of seconds between queries sent by the WSS to the NTP
	servers for updates.
Current time	System time that was current on the WSS when you pressed
	Enter after typing the show ntp command.
Timezone	Time zone configured on the switch. WSS Software offsets the
	time reported by the NTP server based on the time zone.
	Note: This field is displayed only if you change the time zone.
Summertime	Summertime period configured on the switch. WSS Software
	offsets the system time +1 hour and returns it to standard time for
	daylight savings time or a similar summertime period that you
	set.
	Note: This field is displayed only if you enable summertime.
Last NTP update	Time when the switch received the most recent update from an
	NTP server.
NTP Server	IP address of the NTP server.
Peer state	State of the NTP session from the point of view of the NTP
	server:
	•	CORRECT
	•	REJECT
	•	SELCAND
	•	SYNCCAND
	•	SYSPEER
Local state	State of the NTP session from the point of view of the WSS’s
	NTP client:
	•	INITED
	•	START
	•	SYNCED

See Also

•clear ntp server on page 102

•clear summertime on page 105

•clear timezone on page 106

•set ntp on page 121

Nortel WLAN—Security Switch 2300 Series Command Line Reference