Nortel Networks 2300 Series Clear ap boot-configuration, Clear ap radio load-balancing group

AP Commands 251

clear ap boot-configuration

Removes the static IP address configuration for a AP.

Syntax clear ap boot-configuration ap-num

ap ap-num	Number of the AP for which you are clearing static IP information.
Defaults	None.

Access Enabled.

History Introduced in WSS Software 4.1. Option dap removed in 6.0.

Usage When the static IP configuration is cleared for a AP, the next time the AP is rebooted, it uses the standard boot process.

Examples The following command clears the static IP address configuration for AP 1.

WSS# clear ap 1 boot-configuration

This will clear specified AP devices. Would you like to continue? (y/n) [n]y success: static info cleared.

•set ap boot-configuration ip on page 251

•set ap boot-configuration switch on page 255

•set ap boot-configuration vlan on page 256

•show ap boot-configuration on page 370

clear ap radio load-balancing group

Removes an AP radio from its load-balancing group.

Syntax clear ap ap-numberradio {1 2} load-balancing group

ap ap-number	Index value that identifies the AP on the WSS.
radio 1	Radio 1 of the AP.
radio 2	Radio 2 of the AP. (This option does not apply to single-radio models.)

Defaults None.

Access Enabled.

History Introduced in WSS Version 6.0.

Usage If an AP radio has been assigned to an RF load balancing group, you can use this command to remove the AP radio from the group.

Nortel WLAN—Security Switch 2300 Series Command Line Reference