Nortel Networks 2300 Series manual Set radio-profile auto-tune channel-interval

AP Commands 291

•set radio-profileauto-tunechannel-interval on page 281

•set radio-profileauto-tunechannel-lockdown on page 282

•show radio-profile on page 376

set radio-profile auto-tune channel-interval

Sets the interval at which RF Auto-Tuning decides whether to change the channels on radios in a radio profile. At the end of each interval, WSS Software processes the results of the RF scans performed during the previous interval, and changes radio channels if needed.

Syntax set radio-profile name auto-tune channel-interval seconds

name	Radio profile name.
seconds	Number of seconds RF Auto-Tuning waits before changing radio
	channels to adjust to RF changes, if needed. You can specify from 0 to
	65535 seconds.

Defaults The default channel interval is 3600 seconds (one hour).

Access Enabled.

History Introduced in WSS Software Version 3.0.

Usage Nortel recommends that you use an interval of at least 300 seconds (5 minutes).

RF Auto-Tuning can change a radio’s channel before the channel interval expires in response to RF anomalies. Even in this case, channel changes cannot occur more frequently than the channel holddown interval.

If you set the interval to 0, RF Auto-Tuning does not reevaluate the channel at regular intervals. However, RF Auto-Tuning can still change the channel in response to RF anomalies.

Examples The following command sets the channel interval for radios in radio profile rp2 to 2700 seconds (45 minutes):

WSS# set radio-profile rp2 auto-tune channel-interval 2700

success: change accepted.

See Also

•set radio-profileauto-tunechannel-config on page 279

•set radio-profileauto-tunechannel-holddown on page 280

•set radio-profileauto-tunechannel-lockdown on page 282

•show radio-profile on page 376

Nortel WLAN—Security Switch 2300 Series Command Line Reference