Nortel Networks 2300 Series manual SNMPv2c with Informs, SNMPv2c with Traps

IP Services Commands 143

SNMPv2c with Informs

To configure a notification target for informs from SNMPv2c, use the following command:

Syntax set snmp notify target target-num ip-addr[:udp-port-number]v2c community-string inform

[profile profile-name] [retries num] [timeout num]

target-num	ID for the target. This ID is local to the WSS and does
	not need to correspond to a value on the target itself.
	You can specify a number from 1 to 10.
ip-addr[:udp-port-number]	IP address of the server. You also can specify the UDP
	port number to send notifications to.
community-string	Community string.
profile profile-name	Notification profile this SNMP user will use to specify
	the notification types to send or drop.
retries num	Specifies the number of times the WSS Software
	SNMP engine will resend a notification that has not
	been acknowledged by the target. You can specify
	from 0 to 3 retries.
timeout num	Specifies the number of seconds WSS Software waits
	for acknowledgement of a notification. You can
	specify from 1 to 5 seconds.

SNMPv2c with Traps

To configure a notification target for traps from SNMPv2c, use the following command:

Syntax set snmp notify target target-num ip-addr[:udp-port-number]v2c community-string trap

[profile profile-name]

target-num	ID for the target. This ID is local to the WSS and does
	not need to correspond to a value on the target itself.
	You can specify a number from 1 to 10.
ip-addr[:udp-port-number]	IP address of the server. You also can specify the UDP
	port number to send notifications to.
community-string	Community string.
profile profile-name	Notification profile this SNMP user will use to specify
	the notification types to send or drop.

Nortel WLAN—Security Switch 2300 Series Command Line Reference