Nortel Networks 2300 Series manual History, Quickstart, Set auto-config, See Also clear history on

System Services Commands 67

traceroute Print the route packets take to network host

See Also “Using CLI Help” on page 16

history

Displays the command history buffer for the current CLI session.

Syntax history

Defaults None.

Access All.

Examples To show the history of your session, type the following command:

WSS> history

Show History (most recent first)

--------------------------------

[00]show config

[01]show version

[02]enable

See Also clear history on page 54

quickstart

Runs a script that interactively helps you configure a new switch.

(For information, see the “CLI quickstart Command” section of the “WSS Setup Methods” chapter in the Nortel WLAN Security Switch 2300 Series Configuration Guide.)

Caution! The quickstart command is for configuration of a new switch only. After prompting you for verification, the command erases the switch’s configuration before continuing. If you run this command on a switch that already has a configuration, the configuration will be erased. In addition, error messages such as Critical AP Notice for directly connected APs can appear.

set auto-config

Enables a WSS to contact a WLAN Management Software server for its configuration.

Nortel WLAN—Security Switch 2300 Series Command Line Reference