Nortel Networks 2300 Series manual Set port mirror, Syntax set port media-type port-listrj45, Rj45

Port Commands 47

Syntax set port media-type port-listrj45

port-list	List of physical ports. WSS Software sets the preference on all the
	specified ports.
rj45	Uses the copper interface.

Defaults The GBIC (fiber) interface is enabled, and the copper interface is disabled, by default. Access Enabled.

History Introduced in WSS Software Version 4.0. Usage This command applies only to the 2380.

If you set the port interface to RJ-45 on a port that already has an active fiber link, WSS Software immediately changes the link to the copper interface.

Examples The following command disables the fiber interface and enables the copper interface on port 2:

2380# set port media-type 2 rj45

See Also

•clear port media-type on page 25

•show port media-type on page 48

set port mirror

Configures port mirroring. Port mirroring is a troubleshooting feature that copies (mirrors) traffic sent or received by a WSS port (the source port) to another port (the observer) on the same WSS. You can attach a protocol analyzer to the observer port to examine the source port’s traffic. Both traffic directions (send and receive) are mirrored.

Syntax set port mirror source-portobserver observer-port

source-port		Number of the port whose traffic you want to analyze. You can specify
		only one port.
observer-port		Number of the port to which you want the switch to copy the source port’s
		traffic.
Defaults	None.
Access	Enabled.

History Introduced in WSS Software Version 4.1.

Usage The switch can have one port mirroring pair (one source port and one observer port) at a time. The source port can be a network port, AP access port, or wired authentication port. However, the observer port must be a network port, and cannot be a member of any VLAN or port group.

Nortel WLAN—Security Switch 2300 Series Command Line Reference