Nortel Networks 2300 Series Countermeasures, Dtim-interval, Frag-threshold 2346, Qos-mode Wmm

302AP Commands

Table 4: Defaults for Radio Profile Parameters (continued)

	Default	Radio Behavior When
Parameter		Parameter Set To Default
	Value
		Value
countermeasures	Not configured	Does not issue countermeasures against
		any device.
dtim-interval	1	Sends the delivery traffic indication
		map (DTIM) after every beacon.
frag-threshold	2346	Uses the short-retry-count for frames
		shorter than 2346 bytes and uses the
		long-retry-count for frames that are
		2346 bytes or longer.
max-rx-lifetime	2000	Allows a received frame to stay in the
		buffer for up to 2000 ms (2 seconds).
max-tx-lifetime	2000	Allows a frame that is scheduled for
		transmission to stay in the buffer for up
		to 2000 ms (2 seconds).
preamble-length	short	Advertises support for short 802.11b
		preambles, accepts either short or long
		802.11b preambles, and generates
		unicast frames with the preamble length
		specified by the client.
		Note: This parameter applies only to
		802.11b/g radios.
qos-mode	wmm	Classifies and marks traffic based on
		802.1p and DSCP, and optimizes
		forwarding prioritization of AP radios
		for Wi-Fi Multimedia (WMM).
rfid-mode	disable	Radio does not function as a location
		receiver in an AeroScout Visibility
		System.
rts-threshold	2346	Transmits frames longer than 2346
		bytes by means of the Request-to-Send/
		Clear-to-Send (RTS/CTS) method.
service-profile	No service	You must configure a service profile.
	profiles defined	The service profile sets the SSID name
		and other parameters.
wmm-powersave	disable	Requires clients to send a separate
		PSpoll to retrieve each unicast packet
		buffered by the AP radio.
Access Enabled.

NN47250-100 (Version 02.51)