Nortel Networks 2300 Series manual Set ap boot-configuration mesh mode

262AP Commands

•show ap boot-configuration on page 370

set ap boot-configuration mesh mode

Enables WLAN mesh services on the AP.

Syntax set ap ap-numberboot-configuration mesh mode {enable disable}

ap ap-number		Index value that identifies the AP on the WSS.
mode {enable disable}		Enables or disables WLAN mesh services for the AP.
Defaults	Disabled.
Access	Enabled.

History Introduced in WSS Version 6.0.

Usage Use this command to enable WLAN mesh services for an Mesh AP. Prior to deploying the Mesh AP in its final untethered location, you must connect the AP to an WSS switch and enter this command to configure the AP for mesh services.

Examples The following command enables WLAN mesh services for AP 7:

WSS# set ap 7 boot-configuration mesh mode enable

success: change accepted.

See Also

•set ap boot-configuration mesh ssid on page 254

•set service-profile mesh on page 320

•show ap mesh-links on page 357

set ap boot-configuration mesh psk-phrase

Specifies a preshared key (PSK) phrase that a Mesh AP uses for authentication to its Mesh Portal AP.

Syntax set ap ap-numberboot-configuration mesh psk-phrase passphrase

ap ap-number		Index value that identifies the AP on the WSS.
passphrase		An ASCII string from 8 to 63 characters long. The string can
		contain blanks if you use quotation marks at the beginning
		and end of the string.
Defaults	None.
Access	Enabled.

History Introduced in WSS Version 6.0.

NN47250-100 (Version 02.51)