Nortel Networks 2300 Series manual Set radio-profile rts-threshold

AP Commands 307

Syntax set radio-profile name rfid-mode {enable disable}

name	Radio profile name.
enable	Enables radios to function as asset location receivers.
disable	Disables radios from functioning as asset location receivers.

Defaults The default is disable. Access Enabled.

History Introduced in WSS Software Version 5.0.

Examples The following command enables radios managed by radio profile rp1 to act as asset location receivers:

WSS# set radio-profile rfid-mode enable

success: change accepted.

See Also

•set radio-profile mode on page 291

•show radio-profile on page 376

set radio-profile rts-threshold

Changes the RTS threshold for the AP radios in a radio profile. The RTS threshold specifies the maximum length a frame can be before the radio uses the RTS/CTS method to send the frame. The RTS/CTS method clears the air of other traffic to avoid corruption of the frame due to a collision with another frame.

Syntax set radio-profile name rts-threshold threshold

name	Radio profile name.
threshold	Maximum frame length, in bytes. You can enter a value from 256 through
	3000.

Defaults The default RTS threshold for an AP radio is 2346 bytes. Access Enabled.

Usage You must disable all radios that are using a radio profile before you can change parameters in the profile. Use the set radio-profile mode command.

Examples The following command changes the RTS threshold for radio profile rp1 to 1500 bytes:

WSS# set radio-profile rp1 rts-threshold 1500

success: change accepted.

See Also

•set radio-profile mode on page 291

•show radio-profile on page 376

Nortel WLAN—Security Switch 2300 Series Command Line Reference