Nortel Networks 2300 Series manual Show auto-tune neighbors

378AP Commands

Table 16: Output for show auto-tune attributes (continued)

		Field	Description
		Packet Retransmission Count	Number of retransmitted packets sent from the client to the radio
			on the active channel. Retransmissions can indicate that the client
			is not receiving ACKs from the AP radio.
		Phy Errors Count	Number of frames received by the AP radio that had physical
			layer errors on the active channel. Phy errors can indicate
			interference from a non-802.11 device.
		See Also
•	set ap radio auto-tunemax-power on page 265
•	set radio-profileauto-tunechannel-config on page 279
•	set radio-profileauto-tunechannel-holddown on page 280
•	set radio-profileauto-tunechannel-interval on page 281
•	set radio-profileauto-tunepower-backoff-timer on page 282
•	set radio-profileauto-tunepower-config on page 282
•	set radio-profileauto-tunepower-interval on page 283
•	show auto-tune neighbors on page 368
•	show radio-profile on page 376

show auto-tune neighbors

Displays the other Nortel radios and third-party 802.11 radios that a Nortel radio can hear.

Syntax show auto-tune neighbors [ap ap-num[radio {1 2all}]]

ap-num	AP port connected to the AP for which to display neighbors.
ap-num	Number of a AP for which to display neighbors.
radio 1	Shows neighbor information for radio 1.
radio 2	Shows neighbor information for radio 2. (This option does not apply to
	single-radio models.)
radio all	Shows neighbor information for both radios.
Defaults	None.
Access	Enabled.

History Introduced in WSS Software Version 3.0.

Option dap removed in version 6.0.

NN47250-100 (Version 02.51)