Nortel Networks 2300 Series manual Clear spantree portvlancost, Clear spantree portvlanpri

STP Commands 401

See Also

•clear spantree portvlanpri on page 391

•set spantree portpri on page 397

•set spantree portvlanpri on page 398

•show spantree on page 400

clear spantree portvlancost

Resets to the default value the cost of a network port or ports on paths to the STP root bridge for a specific VLAN on a WSS, or for all VLANs.

Syntax clear spantree portvlancost port-list{all vlan vlan-id}

port-list	List of ports. The port cost is reset on the specified ports.
all	Resets the cost for all VLANs.
vlan vlan-id	VLAN name or number. WSS Software resets the cost for only the
	specified VLAN.
Defaults	None.

Access Enabled.

Usage WSS Software does not change a port’s cost for VLANs other than the one(s) you specify. Examples The following command resets the STP cost for port 12 in VLAN sunflower:

WSS# clear spantree portvlancost 12 vlan sunflower success: change accepted.

See Also

•clear spantree portcost on page 390

•set spantree portcost on page 395

•set spantree portvlancost on page 397

•show spantree on page 400

•show spantree portvlancost on page 406

clear spantree portvlanpri

Resets to the default value the priority of a network port or ports for selection as part of the path to the STP root bridge, on one VLAN or all VLANs.

Nortel WLAN—Security Switch 2300 Series Command Line Reference