Nortel Networks 2300 Series manual Set mobility-domain mode seed domain-name

Mobility Domain Commands 231

Syntax set mobility-domain mode member secondary-seed-ip secondary-seed-ip-addr

Defaults None.

Access Enabled.

History Introduced in WSS Software Version 6.0.

Examples Following is the example of mobility-domain secondary-seed-ip.

WSS# set mobility-domain mode member secondary-seed-ip 192.168.1.8

Success: change accepted

set mobility-domain mode seed domain-name

Creates a Mobility Domain by setting the current WSS as the seed device and naming the Mobility Domain.

Syntax set mobility-domain mode seed domain-name mob-domain-name

mob-domain-nameName of the Mobility Domain. Specify between 1 and 32 characters with no spaces.

Defaults	None.
Access Enabled.
History
Version 4.1	Maximum length of mob-domain-nameincreased to 32
	characters.

Usage Before you use this command, the current WSS must have its IP address set with the set system ip- address command. After you enter this command, all Mobility Domain traffic is sent and received from the specified IP address.

You must explicitly configure only one WSS per domain as the seed. All other WSSs in the domain receive their Mobility Domain information from the seed.

Examples The following command creates a Mobility Domain named Santa Clara with the current WSS as the seed:

WSS# set mobility-domain mode seed domain-name Santa Clara mode is: seed

domain name is: Santa Clara

See Also

•clear mobility-domain member on page 218

•show mobility-domain on page 222

Nortel WLAN—Security Switch 2300 Series Command Line Reference