Nortel Networks 2300 Series manual Set radio-profile auth-dot1x, Set radio-profile auth-psk

AP Commands 289

Usage You can enter this command on any WSS in the Mobility Domain. The command takes effect only on that switch.

Examples The following command disables active scan in radio profile radprof3:

WSS# set radio-profile radprof3 active-scan disable

success: change accepted.

See Also show radio-profile on page 376

set radio-profile auth-dot1x

Deprecated in WSS Software Version 3.0. In 3.0, this parameter is associated with service profiles instead of radio

profiles. See set service-profileauth-dot1x on page 307.

set radio-profile auth-psk

Deprecated in WSS Software Version 3.0. In 3.0, this parameter is associated with service profiles instead of radio

profiles. See set service-profileauth-psk on page 309.

set radio-profile auto-tune channel-config

Disables or reenables dynamic channel tuning (RF Auto-Tuning) for the AP radios in a radio profile.

Syntax set radio-profile name auto-tune channel-config {enable disable} [no-client]

name	Radio profile name.
enable	Configures radios to dynamically select their channels when the radios
	are started.
disable	Configures radios to use their statically assigned channels, or the default
	channels if unassigned, when the radios are started.
no-client	Configures radios to change channels regardless of client status. Without
	this option, a radio changes the channel only if the radio does not have
	any active clients on that channel.

Defaults Dynamic channel assignment is enabled by default.

Access Enabled.

History

Version 5.0 Option no-clientadded.

Usage If you disable RF Auto-Tuning for channels, WSS Software does not dynamically set the channels when radios are first enabled and also does not tune the channels during operation.

If RF Auto-Tuning for channels is enabled, WSS Software does not allow you to manually change channels.

Nortel WLAN—Security Switch 2300 Series Command Line Reference