Nortel Networks 2300 Series STP Commands, Set spantree uplinkfast on, Show spantree uplinkfast on

399

STP Commands

Use Spanning Tree Protocol (STP) commands to configure and manage spanning trees on the virtual LANs (VLANs) configured on a WSS, to maintain a loop-free network. This chapter presents STP commands alpha- betically. Use the following table to locate commands in this chapter based on their use.

STP State	set spantree on page 393
	show spantree on page 400
	show spantree blockedports on page 404
Bridge Priority	set spantree priority on page 399
Port Cost	set spantree portcost on page 395
	set spantree portvlancost on page 397
	show spantree portvlancost on page 406
	clear spantree portcost on page 390
	clear spantree portvlancost on page 391
Port Priority	set spantree portpri on page 397
	set spantree portvlanpri on page 398
	clear spantree portpri on page 390
	clear spantree portvlanpri on page 391
Timers	set spantree fwddelay on page 394
	set spantree hello on page 394
	set spantree maxage on page 395
Fast Convergence	set spantree portfast on page 396
	show spantree portfast on page 405
	set spantree backbonefast on page 393
	show spantree backbonefast on page 403
	set spantree uplinkfast on page 399
	show spantree uplinkfast on page 412
Statistics	show spantree statistics on page 407
	clear spantree statistics on page 392

Nortel WLAN—Security Switch 2300 Series Command Line Reference