Nortel Networks 2300 Series manual Set ip telnet server, Syntax set ip telnet port-num

130IP Services Commands

set ip telnet

Changes the TCP port number on which a WSS listens for Telnet management traffic.

Caution! If you change the Telnet port number from a Telnet session, WSS Software immediately ends the session. To open a new management session, you must Telnet to the switch with the new Telnet port number.

Syntax set ip telnet port-num

port-numTCP port number.

Defaults The default Telnet port number is 23. Access Enabled.

Examples The following command changes the Telnet port number on a WSS to 5000:

WSS# set ip telnet 5000

success: change accepted.

See Also

•clear ip telnet on page 102

•set ip https server on page 116

•set ip telnet server on page 120

•show ip https on page 152

•show ip telnet on page 155

set ip telnet server

Enables the Telnet server on a WSS.

Caution! If you disable the Telnet server, Telnet access to the WSS is also disabled.

Syntax set ip telnet server {enable disable}

enable	Enables the Telnet server.
disable	Disables the Telnet server.

Defaults The Telnet server is disabled by default.

Access Enabled.

NN47250-100 (Version 02.51)