Nortel Networks 2300 Series Show ap connection, Connection, Serial-id serial-ID, AP serial ID

AP Commands 381

Table 18: Output for show ap boot-configuration (continued)

Field	Description
Switch	Whether the AP is configured to use a manually specified WSS
	as its boot device.
Mesh	Whether WLAN mesh services are enabled for this
	AP.
IP address	The static IP address assigned to this AP.
Netmask	The subnet mask assigned to this AP.
Gateway	The IP address of the default gateway assigned to this AP.
Switch IP	The IP address of the WSS that this AP is configured to use as its
	boot device (if any).
Switch Name	The name of the WSS that this AP is configured to use as its boot
	device (if any).
DNS IP	The IP address of the DNS server that the AP uses to resolve the
	name of the WSS used as its boot device.
Mesh SSID	The WLAN mesh services SSID this AP is configured to use (if
	any).
Mesh PSK	The preshared key (PSK) the AP uses for authentication with a
	Mesh Portal AP (if any).)

show ap connection

Displays the system IP address of the WSS that booted a AP.

Syntax show ap connection [ap-numserial-id serial-ID]

ap-num		Number of a AP for which to display information about its active
		connection.
serial-id serial-ID		AP serial ID.
Defaults	None.
Access	Enabled.

Usage The serial-idparameter displays the active connection for the specified AP even if that AP is not configured on this WSS. If you instead use the command with the ap-numparameter or without a parameter, connection information is displayed only for APs that are configured on this WSS.

This command provides information only if the AP is configured on the switch where you use the command. The switch does not need to be the one that booted the AP, but it must have the AP in its configuration. Also, the switch that booted the AP must be in the same Mobility Domain as the switch where you use the command.

Nortel WLAN—Security Switch 2300 Series Command Line Reference