Nortel Networks 2300 Series manual Web-portal-acl Portalacl, Portal-acl setting, Web-portal-form

312AP Commands

Table 5: Defaults for Service Profile Parameters (continued)

		Radio Behavior When
Parameter	Default Value	Parameter Set To
		Default Value
web-portal-acl	portalacl	If set to portalacl and the service
		profile fallthru is set to web-
	Note: This is the default	portal, radios use the portalacl
	only if the fallthru type	ACL to filter traffic for Web
	on the service profile	Portal users during authentication.
	has been set to web-	If the fallthru type is web-portal
	portal. Otherwise, the	but web-portal-aclis set to an
	value is unconfigured.	ACL other than portalacl, the
		other ACL is used.
		If the fallthru type is not web-
		portal, radios do not use the web-
		portal-acl setting.
web-portal-form	Not configured	For Web-based AAA users, serves
		the Nortel login page.
web-portal-session-	5	Allows a Web Portal Web-based
timeout		AAA session to remain in the
		Deassociated state 5 seconds
		before being terminated
		automatically.
wep key-index	No keys defined	Uses dynamic WEP rather than
		static WEP.
		Note: If you configure a WEP key
		for static WEP, WSS Software
		continues to also support dynamic
		WEP.
wep active-multicast-index	1	Uses WEP key 1 for static WEP
		encryption of multicast traffic if
		WEP encryption is enabled and
		keys are defined.
wep active-unicast-index	1	Uses WEP key 1 for static WEP
		encryption of unicast traffic if
		WEP encryption is enabled and
		keys are defined.
wpa-ie	disable	Does not use the WPA IE in
		transmitted frames.

Access Enabled.

History Introduced in WSS Software Version 3.0.

Usage You must configure the service profile before you can map it to a radio profile. You can map the same service profile to more than one radio profile.

You must disable all radios that use a radio profile before you can change parameters in the profile. Use the set

radio-profile mode command.

NN47250-100 (Version 02.51)