Nortel Networks 2300 Series manual Clear prompt, Clear system, Syntax clear prompt

System Services Commands 65

clear prompt

Resets the system prompt to its previously configured value. If the prompt was not configured previously, this command resets the prompt to its default.

Syntax clear prompt

Defaults None.

Access Enabled.

Examples To reset the prompt, type the following command:

wildebeest# clear prompt success: change accepted. WSS#

See Also set prompt on page 62. (For information about default prompts, see “Command Prompts” on page 10.)

clear system

Clears the system configuration of the specified information.

Caution! If you change the IP address, any currently configured Mobility Domain operations cease. You must reset the Mobility Domain.

Syntax clear system [contact countrycode idle-timeout ip-address location name]

contact		Resets the name of contact person for the WSS to null.
countrycode		Resets the country code for the WSS to null.
idle-timeout		Resets the number of seconds a CLI management session can remain idle
		to the default value (3600 seconds).
ip-address		Resets the IP address of the WSS to null.
location		Resets the location of the WSS to null.
name		Resets the name of the WSS to the default system name, which is WSS-
		mm-nnnnnn, where mm is the model number and nnnnnn is the
		last 6 digits of the switch’s MAC address.
Defaults	None.
Access	Enabled.
History
Version 4.1		Option idle-timeoutadded.

Nortel WLAN—Security Switch 2300 Series Command Line Reference