Nortel Networks 2300 Series Output for show ap connection, WSS# show ap connection serial-id

382AP Commands

If a AP is configured on this WSS (or another WSS in the same Mobility Domain) but does not have an active connection, the command does not display information for the AP. To show connection information for APs, use the show ap global command on one of the switches where the APs are configured.

Examples The following command displays information for all APs configured on this WSS that have active connections:

WSS# show ap connection Total number of entries: 2

AP Serial Id AP IP Address WSS IP Address

--- ----------- --------------- --------------------------------

2	112233	10.10.2.27	10.3.8.111
4	0333000298	10.10.3.34	10.3.8.111

The following command displays connection information specifically for a AP with serial ID 223344:

WSS# show ap connection serial-id 223344

Total number of entries: 1

AP Serial Id AP IP Address WSS IP Address

--- ----------- --------------- ---------------------------

9 223344 10.10.4.88 10.9.9.11

Table 52 describes the fields in this display.

	Table 19: Output for show ap connection
Field	Description
AP	Connection ID you assigned to the AP.
	If the connection is configured on another WSS, this field
	contains a hyphen ( - ).
Serial Id	Serial ID of the AP.
AP IP Address	IP address assigned by DHCP to the AP.
WSS IP Address	System IP address of the WSS on which the AP has an active
	connection. This is the switch that the AP used for booting and
	configuration and is using for data transfer.

See Also

•show ap config on page 344

•show ap global on page 373

•show ap unconfigured on page 374

NN47250-100 (Version 02.51)