Nortel Networks 2300 Series manual Set service-profile short-retry-count

AP Commands 335

Defaults Shared-key authentication is disabled by default. Access Enabled.

History Introduced in WSS Software Version 3.0.

Usage Shared-key authentication is supported only for encrypted SSIDs. In addition, if you enable shared-key authentication, RSN, WPA, TKIP, and CCMP must be disabled. By default, RSN, WPA, and CCMP are already disabled, but TKIP is enabled; you must manually disable TKIP. To disable TKIP, use the set service-profilecipher-tkip disable command.

Examples The following command enables shared-key authentication in service profile sp4:

WSS# set service-profile sp4 shared-key-auth enable

success: change accepted.

See Also

•set radio-profile mode on page 291

•set service-profilecipher-tkip on page 313

•show service-profile on page 380

set service-profile short-retry-count

Changes the short retry threshold for a service profile. The short retry threshold specifies the number of times a radio can send a short unicast frame without receiving an acknowledgment. A short unicast frame is a frame that is shorter than the frag-threshold.

Syntax set service-profile name short-retry-count threshold

name	Service profile name.
threshold	Number of times a radio can send the same short unicast frame. You can
	enter a value from 1 through 15.

Defaults The default short unicast retry threshold is 5 attempts. Access Enabled.

History Introduced in WSS Software Version 4.1.

Examples The following command changes the short retry threshold for service profile sp1 to 3:

WSS# set service-profile sp1 short-retry-count 3

success: change accepted.

See Also

•set radio-profilefrag-threshold on page 289

•set service-profilelong-retry-count on page 319

•show service-profile on page 380

Nortel WLAN—Security Switch 2300 Series Command Line Reference