Nortel Networks 2300 Series manual Show system output

	System Services Commands 79
	Table 1: show system output
Field	Description
Product Name	WSS model number.
System Name	System name (factory default, or optionally configured with set system name).
System Countrycode	Country-specific 802.11 code required for AP operation (configured with set
	system countrycode).
System Location	Record of WSS’s physical location (optionally configured with set system
	location).
System Contact	Contact information about the system administrator or another person to contact
	about the system (optionally configured with set system contact).
System IP	Common interface, source, and default IP address for the WSS, in dotted decimal
	notation (configured with set system ip-address).
System idle timeout	Number of seconds WSS Software allows a CLI management session (console,
	Telnet, or SSH) to remain idle before terminating the session. (The system idle
	timeout can be configured using the set system idle-timeoutcommand.)
System MAC	WSS media access control (MAC) machine address set at the factory, in 6-byte
	hexadecimal format.
Boot Time	Date and time of the last system reboot.
Uptime	Number of days, hours, minutes, and seconds that the WSS has been operating
	since its last restart.
Fan status	Operating status of the three WSS cooling fans:
	• OK—Fan is operating.
	• Failed—Fan is not operating. WSS Software sends an alert to
	the system log every 5 minutes until this condition is
	corrected.
	Fan 1 is located nearest the front of the chassis, and fan 3 is located nearest the
	back.
Temperature	Status of temperature sensors at three locations in the WSS:
	• ok—Temperature is within the acceptable range of 0° C to
	50° C (32° F to 122° F).
	• Alarm—Temperature is above or below the acceptable range.
	WSS Software sends an alert to the system log every 5 minutes
	until this condition is corrected.

Nortel WLAN—Security Switch 2300 Series Command Line Reference