Nortel Networks 2300 Series manual Show dhcp-server, See Also set interface dhcp-client on

IP Services Commands 157

See Also set interface dhcp-client on page 110

show dhcp-server

Displays WSS Software DHCP server information.

Syntax show dhcp-server [interface vlan-id] [verbose]

interface vlan-id		Displays the IP addresses leased by the specified VLAN.
verbose		Displays configuration and status information for the WSS Software
		DHCP server.
Defaults	None.
Access	All.

History Introduced in WSS Software Version 4.0.

Examples The following command displays the addresses leased by the WSS Software DHCP server:

WSS# show dhcp-server

VLAN Name	Address	MAC	Lease Remaining (sec)
---- -------------- --------------- ----------------- --------------------
1 default	10.10.20.2	00:01:02:03:04:05		12345
1 default	10.10.20.3	00:01:03:04:06:07		2103
2 red-vlan	192.168.1.5	00:01:03:04:06:08		102
2 red-vlan	192.168.1.7	00:01:03:04:06:09		16789

The following command displays configuration and status information for each VLAN on which the DHCP server is configured:

WSS# show dhcp-server verbose

Interface:	0 (Direct AP)
Status:	UP
Address Range:		10.0.0.1-10.0.0.253
Interface:		default(1)
Status:		UP
Address Range:		10.10.20.2-10.10.20.254
Hardware Address:			00:01:02:03:04:05
State:			BOUND
Lease Allocation:			43200 seconds
Lease Remaining:			12345 seconds
IP Address:			10.10.20.2
Subnet Mask:			255.255.255.0
Default Router:			10.10.20.1
DNS Servers:			10.10.20.4 10.10.20.5
DNS Domain Name:			mycorp.com

Table 19 and Table 20 describe the fields in these displays.

Nortel WLAN—Security Switch 2300 Series Command Line Reference