Nortel Networks 2300 Series manual Igmp Snooping Commands, Clear igmp statistics

425

IGMP Snooping Commands

Use Internet Group Management Protocol (IGMP) snooping commands to configure and manage multicast traffic reduction on a WSS. This chapter presents IGMP snooping commands alphabetically. Use the following table to locate commands in this chapter based on their use.

IGMP Snooping State	set igmp on page 416
	show igmp on page 423
Proxy Reporting	set igmp proxy-report on page 419
Pseudo-querier	set igmp querier on page 421
	show igmp querier on page 427
Timers	set igmp qi on page 420
	set igmp oqi on page 418
	set igmp qri on page 420
	set igmp lmqi on page 416
	set igmp rv on page 422
Router Solicitation	set igmp mrsol on page 417
	set igmp mrsol mrsi on page 418
Multicast Routers	set igmp mrouter on page 417
	show igmp mrouter on page 426
Multicast Receivers	set igmp receiver on page 422
	show igmp receiver-table on page 429
Statistics	show igmp statistics on page 431
	clear igmp statistics on page 415

clear igmp statistics

Clears IGMP statistics counters on one VLAN or all VLANs on a WSS and resets them to 0.

Syntax clear igmp statistics [vlan vlan-id]

vlan vlan-id	VLAN name or number. If you do not specify a VLAN, IGMP statistics
	are cleared for all VLANs.
Defaults	None.

Access Enabled.

Nortel WLAN—Security Switch 2300 Series Command Line Reference