Nortel Networks 2300 Series Set service-profile cac-session, Set service-profile cipher-ccmp

322AP Commands

set service-profile cac-session

Specifies the maximum number of active sessions a radio can have when session-based CAC is enabled. When an AP radio has reached the maximum allowed number of active sessions, the radio refuses connections from additional clients.

Syntax set service-profile name cac-session max-sessions

name	Service profile name.
max-sessions	Maximum number of active sessions allowed on the radio.

Defaults The default number of sessions allowed is 14. Access Enabled.

History Introduced in WSS Software Version 4.1.

Usage This command applies only when the CAC mode is session. If the CAC mode is none, you can still change the maximum number of sessions, but the setting does not take effect until you change the CAC mode to session. To change the CAC mode, use the set service-profilecac-modecommand.

Examples The following command changes the maximum number of sessions for radios used by service profile sp1 to 10:

WSS# set service-profile sp1 cac-session 10

success: change accepted.

See Also

•set service-profilecac-mode on page 311

•show service-profile on page 380

set service-profile cipher-ccmp

Enables Counter with Cipher Block Chaining Message Authentication Code Protocol (CCMP) encryption with WPA clients, for a service profile.

Syntax set service-profile name cipher-ccmp {enable disable}

name	Service profile name.
enable	Enables CCMP encryption for WPA clients.
disable	Disables CCMP encryption for WPA clients.
Defaults CCMP encryption is disabled by default.
Access	Enabled.

History Introduced in WSS Software Version 3.0.

Usage To use CCMP, you must also enable the WPA IE.

NN47250-100 (Version 02.51)