Nortel Networks 2300 Series manual Show ap status, Output for show ap mesh-links, Terse

368AP Commands

TX:	307 44279
RX:	315 215046

Table 45 on page 358 describes the fields in the show ap mesh-links output.

Table 12: Output for show ap mesh-links

Field	Description
AP	Identifier for the AP on the WSS.
Name	V-LAN name.
IP-addrs	IP address of AP.
Operational Mode	Indicates whether the AP is a Mesh AP or
	Mesh Portal AP.
Downlink Mesh-APs	Information about the Mesh APs that are
	associated with the Mesh Portal AP.
BSSID	Indicates the BSSID of the Mesh AP.
TX	Indicates the amount of traffic (packets and
	bytes) transmitted to the Mesh AP.
RX	Indicates the amount of traffic (packets and
	bytes) transmited to the Mesh AP.

See Also

•set ap boot-configuration mesh ssid on page 254

•set service-profile mesh on page 320

show ap status

Displays AP and radio status information.

Syntax show ap status [terse] [port-listall [radio {1 2}]]

terse	Displays a brief line of essential status information for each AP.
port-list	List of ports connected to the AP(s) for which to display status.
ap-num	Number of a AP for which to display status.
all	Shows status information for all directly attached APs and all APs
	configured on the switch.

NN47250-100 (Version 02.51)