Nortel Networks 2300 Series manual Show ap vlan

AP Commands 375

Table 13: Output for show ap status (continued)

Field	Description
bssid, ssid	SSIDs configured on the radio and their BSSIDs.
RFID Reports	Status of AeroScout asset tag support.
	• Active—The AeroScout Engine has enabled the
	tag report mode on the AP.
	• Inactive—The AeroScout Engine has not
	enabled, or has disabled, the tag report mode on
	the AP.
	Note: This field is displayed only if the rfid-modeoption is
	enabled on the radio profile that manages the radio.

Table 14: Output for show ap status terse and show ap status terse

Field	Description
Port	WSS port number connected to the AP.
Flg	Operational status flags for the AP.
	For flag definitions, see the key in the command output.
IP Address	IP address of the AP. The address is assigned to the AP by a
	DHCP server.
	Note: This field is applicable only if the AP is configured on the
	WSS as a AP.
Model	AP model number.
MAC Address	MAC address of the AP.
Radio1	State, channel, and power information for radio 1:
	• The state can be D (disabled) or E (enabled).
	• The channel and power settings are shown as
	channel/power.
Radio2	State, channel, and power information for radio 2.
Uptime	Amount of time since the AP booted using this link.

show ap vlan

Displays information about the VLANs that are either locally switched by the specified AP or tunneled from the AP to an WSS switch.

Nortel WLAN—Security Switch 2300 Series Command Line Reference