Nortel Networks 2300 Series manual Positive number for example, +100, displays that, Or shut down

592System Log Commands

Syntax show log trace [{+-/}number-of-messages] [facility facility-name] [matching string] [severity severity-level]

trace		Displays the log messages in the trace buffer.
+-/number-of-messages		Displays the number of messages specified as follows:
		• A positive number (for example, +100), displays that
		number of log entries starting from the oldest in the
		log.
		• A negative number (for example, -100) displays that
		number of log entries starting from newest in the log.
		• A number preceded by a slash (for example, /100)
		displays that number of the most recent log entries in
		the log, starting with the least recent.
facility facility-name		Area of WSS Software that is sending the log message. Type a space
		and a question mark (?) after show log trace facility for a list of valid
		facilities.
matching string		Displays messages that match a string—for example, a username or
		IP address.
severity severity-level		Displays messages at a severity level greater than or equal to the level
		specified. Specify one of the following:
		• emergency—The WSS is unusable.
		• alert—Action must be taken immediately.
		• critical—You must resolve the critical conditions. If
		the conditions are not resolved, the WSS can reboot
		or shut down.
		• error—The WSS is missing data or is unable to form
		a connection.
		• warning—A possible problem exists.
		• notice—Events that potentially can cause system
		problems have occurred. These are logged for
		diagnostic purposes. No action is required.
		• info—Informational messages only. No problem
		exists.
		• debug—Output from debugging.
Defaults	None.
Access	Enabled.

NN47250-100 (Version 02.51)